Oil Suction Filter
The filter is arranged on the suction pipe of the pump, and the pollutants in the oil tank are filtered through the air holes, and the function of the protective pump is provided. However, in order to avoid the pump cavity phenomenon, we must pay full attention to the pressure loss, general use of 100-200 purposes of coarse metal mesh or groove metal material. Therefore, it is not a filter for controlling the contamination concentration of the system.
High-pressure pipeline filter (a)
On the outlet pipe of the pump, there is a function of protecting pollutants from the system. Therefore, the concentration of pollutants in the system can be controlled. However, because it is the high-pressure Supervisor road, to be subjected to the pump pulsation and pressure impact, so filter elements of material, strength should be carefully considered.
High-pressure pipeline filter (b)
In the system, in order to protect the pollution particularly sensitive hydraulic components, to install this filter, also known as Terminal filter. Thus it tends to be smaller than the filtration granularity of other filters. Therefore, you should choose a large capacity when using. In addition to the material of the component, the strength is also the same as (a) should be fully considered.
Related Industry Knowledge
- Brush type
- Development of air filter
- air filter Performance
- High Efficiency air
- Backflow Filter
- Action mechanism
- New Product development
- Selection principle
- The importance of purifying water q...
- How often do air purifiers need to ...
- What are the advantages of activate...
- The advantages of quartz sand filter.